Wednesday, October 18th 2017, 6:31pm UTC+2

You are not logged in.

  • Login
  • Register

Reply

Dear visitor, welcome to SEGGER Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Thursday, March 30th 2017, 11:32am

by SEGGER - Johannes

Hi,

The compiler probably added some preface (additional instructions) to the constructor without source information.
If you continue stepping you should end up in the constructor in source and disassembly.

Could you provide the disassembly Embedded STudio steps into, the call of the constructor and the constructor?

Best regards
Johannes

Monday, March 13th 2017, 11:45am

by 0x0041764C

SES v3.12, C++, Constructor, Debug: 'Step into' always steps into 'Disassemlby' panel

Hi

When I try to 'Step Into' a constructor during debugging the SES does always show the 'Disassembly' panel instead of jumping to the actual c++ code file.
(This is not a new problem in SES v3.12. In SES v3.10i it is the same.)

My work around is to navigate manually to the constructor and set a break point.

Is there a setting to disable that behaviour?

Regards
Anton

dev machine: Windows 10 64bit, SES v3.12
target mcu: NXP(freescale) MKL27Z128... & KM66FN2...