Monday, December 11th 2017, 4:49am UTC+1

You are not logged in.

  • Login
  • Register

Striplar

Beginner

Date of registration: May 26th 2016

Posts: 1

1

Tuesday, December 5th 2017, 4:07pm

Turning on the %v output on J-Link Base

I'm using a J-Link base for programming an EFM32 using the embedded Flash program supplied with Simplicity Studio.
From Segger documentation found elsewhere I can see that you should be able to send it any of the following commands....

power on, power off, power on perm & power off perm.



There doesn't seem to be any way to send these from inside the Simplicity Studio Flash program so I presume that means I need to used software supplied by Segger?


Can someone tell me what the software is that I need for this and how to send these commands? There appears to be a bewildering array of downloads so perhaps someone can tell me which one I need to do this job?

SEGGER - Nino

Super Moderator

Date of registration: Jan 2nd 2017

Posts: 430

2

Tuesday, December 5th 2017, 5:22pm

Hello,

Thank you for your inquiry.

To use the commands you can either use a JLinkScript file or simply enable it through the J-Link Commander which is part of each J-Link software package: https://www.segger.com/downloads/jlink/

There you simply type in power on with your J-Link connected and press enter. The J-Link should output a Voltage now.

Best regards,
Nino