Monday, December 11th 2017, 4:55am UTC+1

You are not logged in.

  • Login
  • Register

Dear visitor, welcome to SEGGER Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Striplar

Beginner

Date of registration: May 26th 2016

Posts: 1

1

Tuesday, December 5th 2017, 4:07pm

Turning on the %v output on J-Link Base

I'm using a J-Link base for programming an EFM32 using the embedded Flash program supplied with Simplicity Studio.
From Segger documentation found elsewhere I can see that you should be able to send it any of the following commands....

power on, power off, power on perm & power off perm.



There doesn't seem to be any way to send these from inside the Simplicity Studio Flash program so I presume that means I need to used software supplied by Segger?


Can someone tell me what the software is that I need for this and how to send these commands? There appears to be a bewildering array of downloads so perhaps someone can tell me which one I need to do this job?

SEGGER - Nino

Super Moderator

Date of registration: Jan 2nd 2017

Posts: 430

2

Tuesday, December 5th 2017, 5:22pm

Hello,

Thank you for your inquiry.

To use the commands you can either use a JLinkScript file or simply enable it through the J-Link Commander which is part of each J-Link software package: https://www.segger.com/downloads/jlink/

There you simply type in power on with your J-Link connected and press enter. The J-Link should output a Voltage now.

Best regards,
Nino